These Press Fit 30 adapter cups allow Shimano Hollowtech II 24mm cranks (9000, 7800, 7900, 6600, 6700 and 5700 series road and XT/XTR mountain), SRAM GXP (Red, Force, Rival), and other 24mm spindle diameter cranks to be installed in any PressFit30 compatible frame set without additional adapters or spacers. These match Shimano factory specification for bearing location, so they are very rigid and durable. Bearings and seals are by Enduro.
Adaptors can be installed and removed as needed. Use blue Loctite 242 and simply press fit these cups and install crank per manufacturer specs. To remove adaptor cups, carefully use a hard plastic punch or aluminum with plastic tip punch to avoid damaging the cup or bearing in the process.
For SRAM GXP cranks (where the non-drive crank spindle steps down to a diameter of 22mm), use the included shim sleeve, seal, and o-ring.
Great condition. Lightly used on a new bike before switching to a BB30 crank. Carefully removed. Bearings are smooth.
Call Anthony 562.467.0093.
These cups are from a BH G5. They're similar, if not the same, to Parlee adapter cups.